-
Recent Posts
Build Log Archive
Categories
Recent Comments
Meta
Category Archives: Lights
New Glareshield, Oil Change Bowerman Hoqiuam Airport for Lunch, and Minor Rewire on VPX
Since the plane is getting close to heading in for paint, I have been tracking and managing the aircraft to be prepared. One of the things on my list was to make sure it had an oil change before it … Continue reading
Posted in Electrical, Glareshield, Lights, Maintenance, Oil Changes, Oregon Aero, Travels, VPX
Leave a comment
Lower Cowl Grinding and Reinforcement for Skybolts, AntiSplatAero Air/Oil Separator and MH Oxygen Dimmer wiring
Today I had a relatively short day, but got a number of things taken care of. I marked the 2″ line on the lower cowl to indicate where to grind out the core to allow the cowl to sit properly … Continue reading
MH Oxygen Dimmer Solution and Cleaveland Tool Tie-Down Ring
With the assistance of my neighbor, the electronics wizard Chris Robinson, we were able to find a solution for dimming the Mountain High 4-ip Oxygen head unit. Thanks Chris, I couldn’t have done it without you! The MH unit requires … Continue reading
It Lives, Wiring is completed and Systems Powered On
Today was another one of those great moments in the build. I started by finishing up the Navworx and GTX 327 wiring harnesses. As luck would have it I ran a few D-Sub pins short of what I needed to … Continue reading
Posted in ADS-B, AFS Electronic Flight Instrument System, Antennas, Avionics, Backup Battery, Battery, Climate Control, Contactors, Electrical, Electronics, ELT, Flight Data Systems CO Detector, Garmin, Gretz Aero Pitot, Instrument Panel, Interior, Lights, Mountain High Oxygen, Navworx, PS Engineering, RockRack Switch, Transponder, TruTrak Auto-Trim, Vans RV10 Project, XM Radio
Leave a comment
Tail Wiring Begins, MH Oxygen, Aux Power, ELT, Left ADHRS, Starter Switch and Transponder Antenna
Before my flight out of town today I was able to get some wiring done. I shifted my focus to the tail area and began to cleanup the routing and getting the devices connected up. I connected up the hoses … Continue reading
Matching Dials Installed, Door Sensors, Wing Root Wiring and Baggage Lights
Over the holidays I took some time off from building to spend time with family. But I was able to get a few things completed in the wiring department. I received my order of matching metal dials and found that the … Continue reading
Wire Routing Completed, Overhead Cables, MH Oxygen Harness and AF-Pilot Harness
Today I completed running all the cables to their general location. Even though there was more conduit room on the right side of the plane, it took quite a bit of effort to get all the wires routed. That is … Continue reading
Instrument Panel Bench Work Complete, Panel Mounting, Panel Wiring Continues
Today was a truly monumental day. The wiring that could be completed on the panel while it was on the bench was completed. I installed the TNC connector on the RG400 cable that connects to the GTN 750. This will … Continue reading
Canopy Interior Paint Finished and Outfitting Overhead Console
Today was the day I could say I was finally finished painting and preparing the canopy interior. After the last coat of paint had dried, I lightly sanded the interior with 2000 grit wet sandpaper. This gave everthing a nice … Continue reading